Beauty and the Beast Craft
Tutorial on how to make Beauty and the Beast Clock Craft
Calories:
Materials
- 1 large white paper plate
- Construction paper: red yellow, black and white
- Flesh Colored Paint
- Glue Stick
- 1 Red Pipe Cleaner
- 1 Black Marker
- Paintbrush
- Single hole punch
- Scissors
Instructions
- Paint the entire front of the paper plate with the flesh-colored paint.
- Set aside for 30 minutes to dry.
- From the white piece of construction paper, cut out the 2 oval eyes, approximately 2 ½ inches long by 1 ¾ inches wide. Set aside.
- From the black construction paper, cut out 2 eyebrows that are about 1 ½ inches across.
- Cut out 2 pupils for the eyes, approximately 1 inch long.
- Set aside the black paper for later use.
- Apply glue to the back of the eyebrows and place in the middle of the paper plate, up at the top.
- With a glue stick, glue the pupils onto the white eyes, towards the inner bottom of each eye.
- Apply glue to the back of each eye and place directly under the eyebrows.
- With the yellow construction paper, cut out a 2 inch diameter circle for the nose.
- Apply to the back of the nose and place on the , directly under the eyes. glueplate
- Set aside the remaining yellow paper for later.
- From the leftover black construction paper, cut out 2 thin strips for the clock hands.
- Strip #1 should be about 2 inches long and strip #2 about 1 ½ inches long.
- Apply glue to the back of the longer strip hand.Place on the plate with one end touching the bottom left side of the nose, pointing to the 7 o’clock position.
- Apply glue to the shorter clock hand.
- Place on the plate with one end touching the bottom right side of the nose, pointing to the 4 o’clock position.
- With the , draw an arrow tip at the end of each clock hand. Draw an arrow tip at the 3 o’clock and 9 o’clock positions.
- Cut out a 1 ½ inch diameter circle for the mouth from the red construction paper.
- Apply glue to the back of the mouth and place it on the paper plate towards the bottom of the plate, in between the clock hands.
- Also, from the red construction paper, cut out a shape (4 ½ inches long and 2 ½ inches wide) that resembles a sombrero hat.
- Cut out the same shape, only smaller, from the yellow paper.
- Turn the “hats” upside down and glue the small yellow one on top of the red one.
- Apply glue to the back of the red piece and place it at the bottom of the plate, directly in the middle.
- Cut out 3 oval shapes (one large and two small) from the leftover yellow construction paper.
- Make the large one 3 inches long and the two small ovals 2 inches long.
- Cut off one end of each piece so that it’s flat.
- Glue the large piece up at the top of the plate, directly in the middle with the flat side on the bottom.
- Glue the smaller pieces on each side of the large one with the flat sides on the bottom.
- With the single hole punch, punch a hole at the top of the paper plate, on each side of the small yellow ovals.
- Thread the red pipe cleaner from the back of the plate and through both holes.
- Pull the pipe cleaner until it rests on top of the 2 small oval shapes.
- Bend about an inch of both ends of the pipe cleaner several times. Apply glue to the back of each end and press against the paper plate.